BX (Moulded Cog)

Final Steps

1. We need to now apply a correction factor to the belt length of minus 43mm that apply to all BX section belts.
   Example:
   Calculated length 1589mm - 43mm Correction factor = 1546mm Belt Length 
   

2. Now we have to convert from millimeters to inches by simply dividing by 25.4
   Example:
   Belt length 1546mm / 25.4mm  = 60.86 inches Belt Length .

3. You may need to round up or down to the nearest whole or half inch size. This rounding is dependent on how much tension adjustment you have, but should not normally exceed 1/2" inch
   Important Note: Whether you can rounding up or down is dependent on the adjustment point when you measured the Centre Distance.
   Example:
   Belt length 60.86 inches rounded up = 61 inch Belt Length. (If adjustment allows)

4. All that is needed now is to put the section in front of the size and you have the correct type.
   Example:
   BX Belt Section + 61 inch belt length = BX61

   Click Here for BX section V-Belts